[ENG] IEC 60079- Electrical Apparatus for Explosive Gas Atmosphere

IEC 60079- ELECTRICAL APPARATUS FOR EXPLOSIVE GAS ATMOSPHERES

Part 0 Ed. 6.0/2011 General requirements

Part 1 Ed. 6.0/2007 Equipment protection by flameproof enclosures “d”

Part 2 Ed. 5.0/2007 Equipment protection by pressurized enclosures “p”

Part 3 Ed. 1.0/1963 Spark test apparatus for intrinsically safe circuits (Withdrawn)

Part 4 Ed. 1.0/1966 Method of test for ignition temperature (Withdrawn)

Part 5 Ed. 3.0/2007 Equipment protection by powder filling “q”

Part 6 Ed 3.0/2007 Equipment protection by oil immersion “o”

Part 7 Ed. 4.0/2006 Equipment protection by increased safety “e”

Part 8 Ed. 1.0/1969 Classification of maximum surface temperature (Withdrawn)

Part 9 Ed. 1.0/1979 Marking (Withdrawn)

Part 10 Ed. 1.0/2008 Classification of hazardous areas

10-1 Explosive gas atmospheres

10-2 Combustible dust atmospheres

Part 11 Ed. 6.0/2011 Equipment protection by intrinsic safety “i”

Part 12 Ed. 1.0/1978 Classification of mixtures of gases of vapours with air according to their maximum experimental safe gaps and minimum igniting currents (Withdrawn)

Part 13 Ed. 1.0/2010 Equipment protection by pressurized room “p”

Part 14 Ed. 4.0/2007 Electrical installations design, selection and erection

Part 15 Ed. 4.0/2010 Equipment protection by type of protection “n”

Part 16 Ed. 1.0/1990 Artificial ventilation for the protection of analyzer(s) houses

Part 17 Ed. 4.0/2007 Electrical installations inspection and maintenance

Part 18 Ed. 3.0/2009 Equipment protection by encapsulation “m”

Part 19 Ed. 3.0/2010 Equipment repair, overhaul and reclamation

Part 20 Ed. 1.0/2010 Material characteristics for gas and vapour classification – Test methods and data

Part 21 N/A

Part 22 N/A

Part 23 N/A

Part 24 N/A

Part 25 Ed. 2.0/2010 Intrinsically safe electrical systems

Part 26 Ed. 2.0/2006 Special requirements for construction test and marking of zone 0 electrical apparatus

Part 27 Ed. 2.0/2008 Fieldbus intrinsically safe concept (FISCO) (Withdrawn)

Part 28 Ed. 1.0/2006 Protection of equipment and transmission systems using optical radiation

Part 29 Ed. 1.0/2007 Gas detectors

Part 30 Ed. 1.0/2007 Electrical resistance trace heating

Part 31 Ed. 1.0/2008 Equipment dust ignition protection by enclosure “t”

Part 32 Ed. 1.0/ – Electrostatic Hazards – Guidance (DRAFT)

Part 33 Ed. 1.0/2012 Equipment protection by special protection ‘s’

Part 34 N/A

Part 35 Ed .1.0/2011 Caplights for use in mines susceptible to firedamp

Note that the 60079 series of standards will gradually address dust hazards as well as gas/vapour hazards. The standard number will have an additional suffix 1 or 2. Thus, for example, 61241-14 (see below) will be replaced by 60079-14-2 [installation for equipment in dust hazards], with 60079-14-1 dealing with installations in gas/vapour hazards.

(Note. BLACK = Usually used, RED = Withdrawn/Not Applicable, BLUE = Rarely used)

(Gathered from many sources in the internet)

[ENG] IEC 60079- Electrical Apparatus for Explosive Gas Atmosphere

Leave a comment Cancel reply

Categories

Share this:

Related

Leave a comment Cancel reply

Categories